The EP Greenhouse reducer is a concise and lightweight reduction gearbox with an integrated limit switch system that’s ideal for assembly of a locally available electric engine. The gear driver can be used in manually-controlled or climate-managed ventilation and display systems in greenhouses. The quick and easy-to-install EP reducer can be rainproof and windproof. The reducer includes a high protection class (IP65) and can be used in an ambient temperature of 0-60 °C.

The low-noise geared motor for Greenhouse has a gearwheel transmission and a worm wheel transmission, which are integrated in an aluminum precision housing. The self-braking worm wheel tranny means that the drive shaft can be locked when the decrease geared motor is not running. The fully sealed reduction gear driver comes with an growth chamber with a diaphragm to keep carefully the gear essential oil at a minimal pressure under all situations, even at high temperature ranges. Thanks to the utilization of an growth chamber, the gear motor can be installed in any placement. There are no limitations, because there is no dependence on a bleed plug. The sealed reduction reducer keeps the gear essential oil of the geared motor in ideal condition because of its entire operating life time. The gear driver is ideal for discontinuous use, operating course s3-30%, with a maximum activation period of 25 minutes.

The Gear box reduction geared motor has an FT85 motor assembly flange, on to which the right IEC standard motor can certainly be installed (EN 50347).

The Gear box includes a rotating limit switch system with operating switches and circuit breakers (NC contacts) for turning off at the end positions. The limit switch system is installed within an built-in chamber and is enclosed by an impact-resistant plastic cover. The limit change system is obtainable and easy to adjust. The limit switch system’s maximum switching range is certainly 40 or 64 revolutions of the drive shaft. The cabling is linked in spring-clip connections. The reducer comes with an IP68 M16 x 1.5 cable gland (5-9 mm cable) for the cable feed-through.

The reducer for greenhouse includes 16 teeth 5/8”x3/8” sprockets, keys and fasteners. The accompanying chain couplings and assembly plates can be found as accessories.

Optimum drive torque of 150 Nm or 450 Nm.
Rotational speeds of 3 or 5 rpm for a mains frequency of 50 Hz or 3.6 or 6 rpm for a mains frequency of 60 Hz in case of program of 4-pole electric motor.
Protection class IP65.
May be used in ambient temperature ranges of 0-60°C.
Ideal for discontinuous use, operating class s3-30%, optimum activation time 25 mins.
Equipped as standard with 16-tooth galvanised chain coupling 5/8″x3/8″.
FT85 motor assembly flange for installing IEC standard motor (EN 50347).
Maximum switching range of limit switch program 40 or 64 revolutions of the drive shaft.
IP68 M16x1.5 cable gland for cable feedthrough (5-9 mm cable).